Developer Instructions

Instructions for Turning the Developer On

  1. Turn the WASH knob on the front of the developer to the CLOSED position. Leave FIX and DEVELOPER knobs in the CLOSED position.
  2. Turn the water ON by turning the green valves 1 and 2 parallel to the pipes and the floor.
  3. Flip the RED switch on the right side of the developer to ON.
  4. Press the RUN button on the front of the developer.
    Note: Wait 20 minutes for the developer to warm up and the READY light to illuminate.

Inserting Film:

  1. Insert the film LENGTHWISE into the developer feed. The minimum length must be 10 cm or the rollers will jam.

Waking up developer:

  1. If the developer is asleep, press the RUN button on the front of the developer.
    Note: Wait 20 minutes for the developer to warm up and the READY light to illuminate.

Updated 10-24-2014 MEZ

Instructions for Turning the Developer Off

  1. Flip the RED switch on the right side of the developer to OFF.
  2. Turn the water OFF by turning the green valves 1 and 2 perpendicular to the pipes and the floor.
  3. Turn the WASH knob on the front of the developer to the OPEN position.
  4. Leave the FIX or DEVELOPER knobs in the CLOSED position.
  5. Open the feed tray cover to prevent condensation.
    Note: Do not refill DEVELOPER or FIXER solutions. If solutions are running low, seek one of the contact individuals.

Contact Information:
Dr. MacDonald: DRC 7009 9-7824
Megan Zavorka: DRC 7068 9-7826
Dr. Mott: DRC 7012 9-3177
Mary Anne Phillippi: DRC 7020 9-3170

Updated 10-24-2014 MEZ